Mask Making and Packing Machine Maintenance Tips

The maintenance and repair of the plane mask machine is very important. The maintenance of the plane mask machine can bring the mask machine better work, more safety and higher efficiency, so how should we do it when performing maintenance on the plane mask machine?

The plane mask machine can be maintained according to the following aspects and it is necessary to shut down during the maintenance process:
 

1. Ultrasound system

Check whether the system of the ultrasonic mask machine is kept clean, especially the ultrasonic electric box, vibrator (transducer), and the welding head must be dry and clean without water, and the connection line must be firm and frequent to check the wear of the ultrasonic welding head Pay attention to observe the scale of the voltmeter and ammeter pointer changes on the ultrasonic electric box.
 

2. Pneumatic system：

The air filter cup of the mask equipment needs to be checked to see if there is any water, but also to the water compressor, and the area with high humidity should be drained to the air compressor every day to see if all the trachea cylinders are leaking. Cylinder magnetic anti-inductor Orientation and normal operation.
 

3. Exterior

Masks are used to wear on the face, and medical masks need to enter the operating room. The production of masks requires neat cleaning of the mask machine equipment. Every day after work, you need to arrange personnel to shut down the mask machine equipment after power off. Wash the work surface and the plate with masks on it. Note that you can't use water to clean, and use non-toxic and volatile cleaning liquid such as alcohol to clean the equipment.

4. Electrical system

Check whether the circuit connector of the mask machine is loose, whether the main power cord and branch signal line are worn or aging. Will the electrical equipment be loose? Is the electrical box kept in a dry environment? Is the exhaust fan normal? Work etc.

The transmission system includes motors, gears, reducers, sprockets, chains, conveyor belts, etc. We must check whether the motor has dust and other things attached to affect heat dissipation, whether the gears and sprockets are oiled, and if there are attachments, they should Clean up, is the chain tightness suitable? Is there any foreign matter not cleaned up? Is there any looseness in the connecting screws between the transmission parts? The lubricating oil of the reducer is not enough, usually the machine needs to be replaced once in 1000-1500 hours.
 

6. Antirust

The equipment must not stick to corrosive liquids and objects. Sweat can easily cause equipment parts to rust. If the equipment is not in operation for a long time, it is necessary to apply anti-rust oil to the transmission system of the mask and the parts that are prone to rust.